Hi

We are in the process to fine tune a K100RT 2v.
Replaced old houses.
Syncronize inlet and are into the temp gage values.
It should read 200 Ohm at warm engine ( fan starts ) but it reads 240 Ohm.
1 KOhm at cold engine.

Any figures to test the unit.

Hi Tibbe,

have a look Here

Its quite far down the page - great work from Bertrand Vogel!!

Hi Rene

Great tips.
The sensor seems witing specification, will look at all the other tips of that page.
The engine are running fine though a bit rich leaving black smoke att acc and consuming appr. 6.5@100kmh.
Next item can be to adjust the CO and if that doesn't do the trick check the flowmeter.

BG
/Sven-Erik